Back to the main page Back to category Preamps and Channel Strips
musical instrument details
AEA RPQ Ribbon Pre (2-Ch FET Mic Preamp w/Curve)
Estimated price for orientation: 1 575 $
Category: Preamps and Channel Strips
Class:
Description Condition: New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. See all condition definitions- opens in a new window or tab ... Read moreabout the condition Brand: AEA MPN: RPQ UPC: Does not apply
The AEA RPQ 2-channel microphone preamp makes ribbon mics (and any other mic in your collection) sound great. Its high headroom, 80dB of clean gain, and ultra-quiet performance make the RPQ a great choice, while a Curve-Shaper function helps you get the best performance possible out of your ribbon mic. This function allows you to minimize proximity effect while enhancing the highs. At a rackmountable 1U, this preamp is as compact as it is versatile and powerful. Features such as JFET circuitry, a wide dynamic range, and road-tough construction help make the RPQ an impressive mic preamp! AEA RPQ 2-channel Ribbon Microphone Preamp at a Glance:
Plenty of clean gain and headroom
Ideal for ribbon mics
Add some "air" to your ribbon
Plenty of clean gain and headroom
The AEA RPQ Ribbon Preamp with Curve-Shaping provides two channels of high-quality, high-gain, low-noise microphone preamplification, and unlike the TRP provides phantom power for active electronics. Particularly well-suited for use with ribbon microphones, it delivers the speed, precision, quietness, and headroom needed for today's high-resolution recordings. The JFET circuit design generates up to 80dB of clean and quiet gain, with extended bandwidth from below 1Hz to beyond 200kHz, for dynamic range and transient response that complements all of your microphones. Ideal for ribbon mics
The RPQ's Curve-Shaper gives you the tools to control your ribbons. Ribbon mics are capable of delivering strong sub-woofer lows, and can have a significant bass proximity effect. Such strong low-frequency content can mask high-frequency intelligibility, so the tunable LF filter was engineered to tame low-frequency energy to appropriate levels. Add some "air" to your ribbon
The HF filter enables you to extend the high end adding a little extra "presence" or "air" to the pickup. The HF filter compensates for the high-frequency roll-off that is inherent to most ribbon microphones, distant mic placement, or an overly "dry" acoustical environment. AEA RPQ 2-channel Ribbon Microphone Preamp Features:
80dB of gain at 1kHz, balanced-in to balanced-out
Noise figure, rms A-weighted: EIN Balanced microphone input impedance > 10 kO
Green, red, and yellow LEDs indicate line level
XLR output max level into 600O load: +28 dBu, balanced; +22 dBu, unbalanced
TRS output max level into 100 kO load: +22 dBu, unbalanced
Grayhill series 71 stepped gain switch
Rotary potentiometers detented at 12:00 o'clock position
Metallic blue and steel gray powder-coat finish
Silkscreened engraved legends and single line schematic
Detachable rack ears included
1U steel and aluminum chassis
Dimensions: 17.25" W, 11" D, 1.7" H
Weight: 6.75 lbs.
The AEA RPQ 2-channel microphone preamp works wonders with your ribbon mic!RETURN INFORMATION
We want you to be completely happy with your purchase from Sweetwater. If you are not satisfied with your product, you may return it for a refund of the purchase price within 30 days. If your purchase was eligible for Free Shipping, the shipping cost will be deducted from your credit or refund. Returns must be in the complete and original packaging with all accessories and complete documentation (Owner's Manual, warranty card, quick start guides, etc.), show no signs of wear or use, and include a Return Authorization number or be subject to a restocking fee. Some products are not returnable, including: Special orders Software Oversized or overweight items Discontinued products, closeouts, and used products Cymbals Tubes Speakers Drumsticks Guitar strings Personal items (earphones, harmonicas, mouthpieces, etc.)
Description
| Condition: | New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable). Packaging should be the same as what is found in a retail store, unless the item is handmade or was packaged by the manufacturer in non-retail packaging, such as an unprinted box or plastic bag. See the seller's listing for full details. See all condition definitions- opens in a new window or tab ... Read moreabout the condition | Brand: | AEA |
| MPN: | RPQ | UPC: | Does not apply |
The AEA RPQ 2-channel microphone preamp makes ribbon mics (and any other mic in your collection) sound great. Its high headroom, 80dB of clean gain, and ultra-quiet performance make the RPQ a great choice, while a Curve-Shaper function helps you get the best performance possible out of your ribbon mic. This function allows you to minimize proximity effect while enhancing the highs. At a rackmountable 1U, this preamp is as compact as it is versatile and powerful. Features such as JFET circuitry, a wide dynamic range, and road-tough construction help make the RPQ an impressive mic preamp! AEA RPQ 2-channel Ribbon Microphone Preamp at a Glance:
Plenty of clean gain and headroom
Ideal for ribbon mics
Add some "air" to your ribbon
Plenty of clean gain and headroom
The AEA RPQ Ribbon Preamp with Curve-Shaping provides two channels of high-quality, high-gain, low-noise microphone preamplification, and unlike the TRP provides phantom power for active electronics. Particularly well-suited for use with ribbon microphones, it delivers the speed, precision, quietness, and headroom needed for today's high-resolution recordings. The JFET circuit design generates up to 80dB of clean and quiet gain, with extended bandwidth from below 1Hz to beyond 200kHz, for dynamic range and transient response that complements all of your microphones. Ideal for ribbon mics
The RPQ's Curve-Shaper gives you the tools to control your ribbons. Ribbon mics are capable of delivering strong sub-woofer lows, and can have a significant bass proximity effect. Such strong low-frequency content can mask high-frequency intelligibility, so the tunable LF filter was engineered to tame low-frequency energy to appropriate levels. Add some "air" to your ribbon
The HF filter enables you to extend the high end adding a little extra "presence" or "air" to the pickup. The HF filter compensates for the high-frequency roll-off that is inherent to most ribbon microphones, distant mic placement, or an overly "dry" acoustical environment. AEA RPQ 2-channel Ribbon Microphone Preamp Features:
80dB of gain at 1kHz, balanced-in to balanced-out
Noise figure, rms A-weighted: EIN Balanced microphone input impedance > 10 kO
Green, red, and yellow LEDs indicate line level
XLR output max level into 600O load: +28 dBu, balanced; +22 dBu, unbalanced
TRS output max level into 100 kO load: +22 dBu, unbalanced
Grayhill series 71 stepped gain switch
Rotary potentiometers detented at 12:00 o'clock position
Metallic blue and steel gray powder-coat finish
Silkscreened engraved legends and single line schematic
Detachable rack ears included
1U steel and aluminum chassis
Dimensions: 17.25" W, 11" D, 1.7" H
Weight: 6.75 lbs.
The AEA RPQ 2-channel microphone preamp works wonders with your ribbon mic!
Plenty of clean gain and headroom
Ideal for ribbon mics
Add some "air" to your ribbon
Plenty of clean gain and headroom
The AEA RPQ Ribbon Preamp with Curve-Shaping provides two channels of high-quality, high-gain, low-noise microphone preamplification, and unlike the TRP provides phantom power for active electronics. Particularly well-suited for use with ribbon microphones, it delivers the speed, precision, quietness, and headroom needed for today's high-resolution recordings. The JFET circuit design generates up to 80dB of clean and quiet gain, with extended bandwidth from below 1Hz to beyond 200kHz, for dynamic range and transient response that complements all of your microphones. Ideal for ribbon mics
The RPQ's Curve-Shaper gives you the tools to control your ribbons. Ribbon mics are capable of delivering strong sub-woofer lows, and can have a significant bass proximity effect. Such strong low-frequency content can mask high-frequency intelligibility, so the tunable LF filter was engineered to tame low-frequency energy to appropriate levels. Add some "air" to your ribbon
The HF filter enables you to extend the high end adding a little extra "presence" or "air" to the pickup. The HF filter compensates for the high-frequency roll-off that is inherent to most ribbon microphones, distant mic placement, or an overly "dry" acoustical environment. AEA RPQ 2-channel Ribbon Microphone Preamp Features:
80dB of gain at 1kHz, balanced-in to balanced-out
Noise figure, rms A-weighted: EIN Balanced microphone input impedance > 10 kO
Green, red, and yellow LEDs indicate line level
XLR output max level into 600O load: +28 dBu, balanced; +22 dBu, unbalanced
TRS output max level into 100 kO load: +22 dBu, unbalanced
Grayhill series 71 stepped gain switch
Rotary potentiometers detented at 12:00 o'clock position
Metallic blue and steel gray powder-coat finish
Silkscreened engraved legends and single line schematic
Detachable rack ears included
1U steel and aluminum chassis
Dimensions: 17.25" W, 11" D, 1.7" H
Weight: 6.75 lbs.
The AEA RPQ 2-channel microphone preamp works wonders with your ribbon mic!
RETURN INFORMATION
We want you to be completely happy with your purchase from Sweetwater. If you are not satisfied with your product, you may return it for a refund of the purchase price within 30 days. If your purchase was eligible for Free Shipping, the shipping cost will be deducted from your credit or refund. Returns must be in the complete and original packaging with all accessories and complete documentation (Owner's Manual, warranty card, quick start guides, etc.), show no signs of wear or use, and include a Return Authorization number or be subject to a restocking fee. Some products are not returnable, including: Special orders Software Oversized or overweight items Discontinued products, closeouts, and used products Cymbals Tubes Speakers Drumsticks Guitar strings Personal items (earphones, harmonicas, mouthpieces, etc.)
We want you to be completely happy with your purchase from Sweetwater. If you are not satisfied with your product, you may return it for a refund of the purchase price within 30 days. If your purchase was eligible for Free Shipping, the shipping cost will be deducted from your credit or refund. Returns must be in the complete and original packaging with all accessories and complete documentation (Owner's Manual, warranty card, quick start guides, etc.), show no signs of wear or use, and include a Return Authorization number or be subject to a restocking fee. Some products are not returnable, including: Special orders Software Oversized or overweight items Discontinued products, closeouts, and used products Cymbals Tubes Speakers Drumsticks Guitar strings Personal items (earphones, harmonicas, mouthpieces, etc.)