2x Peavey PV-1500 Stereo Power Amplifier 1 Furman M-8X Power Conditioner 1 BBE Sound Sonic Maximizer 882i with Road Runner Heavy Duty Traveling Case A Merit Series Power Conditioner is the perfect low-cost AC power solution for any rack mount system. Install an M-8x in to the top slot of your rack, and the eight switched outlets in the rear panel will power up and protect all your equipment up to a 15-amp load. The M-8x is designed for applications where lights are not required. The BBE 882i Sonic Maximizer is perfect for pro studios, sound reinforcement, clubs, and other venues requiring balanced outputs. Designed for uses requiring low noise, high headroom, and +4dBu input levels. It provides either stereo processing or processing for two separate mono channels, brightening, clarifying, and adding fullness to the sound. Features 5-segment LED output meters, +23dBu headroom, XLR and 1/4" stereo inputs and outputs, hardwired bypass, and a bypass switch for comparison of processed to unprocessed signals. Single rackspace. The Peavey PV 1500 Power Amp features Peavey's patented DDT distortion detection technique that virtually eliminates distortion. It also features Peavey's patented V-cooling design, which cools the power transistors more evenly than traditional heat-sink designs. 2-rackspace chassis. PV 1500 Power Amp Stereo Mode: 4 ohms: 500W RMS x 2 Stereo Mode: 8 ohms: 300W RMS x 2 Bridge Mode-Mono: 8 ohms: 1000W RMS Inputs: XLR, 1/4 inch and barrier strip Detented input gain control Binding post and Speakon output connectors Separate Speakon mono bridge output Mode switch for stereo or bridge operation Low-cut filter switch for 40Hz low cut filter Thru/low output jacks and high output jacks LED indicators for input signal, DDT and power Peavey's famous DDT compression system Total Harmonic Distortion: Less than 0.03% 20Hz to 20kHz, 10dB below rated power in stereo mode both channels driven Frequency Response: 20Hz to 20kHz Damping Factor: greater than 300 Hum and Noise: 100dB Rackspaces: 2U 882i Sonic Maximizer Process Mode: Program controlled Bypass Mode: 10Hz-50kHz, ±0.5dBu, 0dBu input Signal to Noise Ratio: 115dB Process IN THD, Process mode: less than 0.025% 20-20kHz Bypass mode: less than 0.002% 20-20kHz Maximum Output: +23dBu (may vary due to control settings) Input Impedance: 14.7K Ohms, balanced 1/4" stereo phone jack or XLR jack. Pin #2 is the hot or "+" signal. Output Impedance: 600 Ohms, balanced 1/4" stereo phone jack or XLR jack. Pin #2 is the hot or "+" signal. Sensitivity: -45dBu for maximum process Maximum Process: +12dBu boost at 5kHz, 0dBu input Lo Contour: +12dBu adjustment at 50Hz, 0dBu input Furman M-8x Power Conditioner Maximum Output Current:15 amps Line Cord:6 ft., captive, 14 AWG, with 3-conductor Edison plug Operating Voltage:120VAC 60Hz Spike Protection Mode: Line to neutral Energy Dissipation:170 joules Peak Impulse Current:12,000 amps Maximum Continuous Operating Voltage:130 VAC RMS Let Through Voltage (@ 125 amps, 8/20uS waveform)400 volts Noise Attenuation:Transverse mode: Greater than 23dB, 200Khz to 10 Mhz Dimensions:1.75” H x 19” W x 7.5” D Weight: 4.9 lbs. Safety Agency Listing:cTUVus What’s Included: 2 x Peavey PV-1500 Stereo Power Amp 1 x Furman M-8x Power Conditioner 1 x Sonic Maximizer 882i 4 x Power Cords 1 X Road Runner Heavy Duty Traveling Case   This Professional Audio Equipment was removed from a working environment. Completely tested by a technician and a DJ. Software & discs NOT included. 100% working condition. 30 Day DOA Warranty.