The body was built in the USA by Warmoth Guitar Products, and made of just 2 pieces of alder like the Clapton Custom Shop models.It was gilded with genuine 23K double patent gold leaves, and I had it finished professionally finished in translucent candy Tangerine. Some use imitation leaves as they cost $10 instead of $160, I have personally used both and still prefer the shine and look of real gold (even with that translucent color coat).The hardtail bridge is from Gotoh and features notched saddles for better tuning stability.The primary ones are couple of scratches that happened during the finishing or buffing around the lower bout (see close up picture).There are also couple spots were the sanding went through the tangerine color coat, those are however impossible to see once the bridge, neck plate, and pickguard are installed (but I like to mention it for full disclosure ).  Most of the pickguard assembly is stock, and the protective film is still on it, but I did use a new set of Fender 25dB midboost circuit + pots.The reason is simply that in order to fit the active electronics in a body without dedicated routing you need to sand one corner of the board and remove the TBX master tone control.