SPECIFICATIONS Compressor Attack Time: FAST; measured by doing 18 dB of Gain Reduction. The time to 18 dB of Gain Reduction is less than 1mS. 12 dB of the 18 are reached in .4mS.
SLOW; for 6 dB of GainReduction, 100mS Compressor Release Time: FAST; From 12 dB of Gain Reduction to No Gain Reduction. 11 of 12 dB are reached in 50mS (Non Program Dependant Release)
SLOW; 20 sec for a full 12 dB release with PDR enabled. Limiter Attack Time: less than 1uS. Limiter Release Time: 60mS for 6 dB of Gain Reduction. Maximum Signal Level: Input or Output, +25 dBm Noise Floor: -88 dBm measured 20Hz to 20kHz Frequency Response: 5Hz to 55kHz (Hara Mode) Limiter Slope: Greater than 10 to 1   INTERFACING Input: Floating, balanced. Maximum input is +25 dBm. The connectors are XLR. Output: Floating, balanced. Maximum output is +25 dBm. The connectors are XLR. For Input and Output: Pin 2 is Sig + , Pin 3 is Sig- , Pin 1 is GND Side Chain Connections: Floating, balanced. Connections are made by using a DB-15 Male Connector. This is a loop insert and must be normaled back to the STC-8. Unbalanced Connections: Are made by tying the SIG- Pin to the GND Pin. If the connection is an input, it is best to tie at the signal source. If the connection is an output, it is best to tie at the STC-8 connector. Power: 100, 120, 230,240 volt; 50/60 Hz; 55 watts
             MDL .6A Fuse for 100V and 120V
             MDL .3A Fuse for 230V and 240V Pilot Lamp: # 7335 Shipping Weight: 19 lbs. (8.6 kg) Depth Behind Panel: 12.5 inches (31.75 cm) plus cabling Panel Height: 2 rack spaces