We're selling this new pair at our wholesale cost. They've been here too long. We gotta clear out inventory.
Authorized dealer.  These are really accurate sounding monitors! Trust your mixes!These monitors were engineered by AVID / Digidesign and built by PMC using Advanced Transmission Line Technology.What’s in the Boxes?
• Two RM1 monitors • One AC power cable • One RJ45 cable • Digidesign Registration Information Card
Features
• Active, bi-amped near field monitors
• Digital and analog inputs
• Proprietary drivers, digital electronics, power amp and cabinet engineering provide unrivalled tonal accuracy, clarity and dynamic  range with exceptionally low distortion
• Onboard DSP:
• Manages the digital crossover, for clearer imaging
• Provides gain trim (sensitivity), low- and high-frequency adjustment and L/R channel assignment
• Provides Bass Port Emulation, an alternate listening mode in which the RMS speakers emulate the tonality of a ported bass reflex speaker
• Sound dispersion design maintains accurate frequency response even when listening in off-axis position.
About the Speakers
The Digidesign RM1 are two-way (bi-amped) active reference monitors with innovations
in amplifier and crossover design and include PMC’s ATL™ (Advanced Transmission Line) technology.
ATL Technology by PMC
PMC has taken loudspeaker design to the highest level with the use of ATL (Advanced Transmission
Line). These designs utilize sophisticated cabinets, proprietary drive units and special absorption materials.
How ATL Works
The main driver is placed at one end of a long
tunnel (the transmission line), which is comprised
of a series of internal baffles within the
cabinet. The transmission line is lined with
acoustic material that is designed to absorb the
upper bass range that radiates from the rear of
the main driver.
The lowest frequencies emerge from the large
vent at the end of the tunnel, in phase with the
main driver, extending its LF output. The pressure
created within the line controls the main
driver over a wide frequency range, dramatically
reducing unnecessary excursions and the resulting
distortion.
The mid range in turn appears cleaner and
clearer as it is not masked by harmonic distortion
residing in the very low frequencies. This
technology produces a higher SPL and lower
bass extension than a ported or sealed cabinet of
a similar size using identical drivers.
Drivers
LF drive units are optimized for an ATL design.
1-inch, soft dome, ferro-fluid cooled HF driver.
Amplifier
In the RM series both HF and LF drive units are
independently driven by separate low-distortion,
analog-controlled “Class D” power amplifiers.
This type of amplifier combines the efficiency
and size advantages of a digital amplifier
with the precision, control and sound quality of
linear amplification.
DSP and Crossover
Within the RM series, the crossover function is
handled by a digital 48-bit fixed-point processor.
The powerful DSP processing engine handles
the audio signal in the digital domain for
precise control and integration of the drive
units along with the EQ parameters, Bass Port
emulation and Left/Right channel selection.
Clock
The analog input ADC (Analog-to-Digital Converter)
is sampled at 96 kHz, 24 bits and is
locked with a discrete low-noise clock oscillator.
We have had this available to listen to so technically they are a demo model, altho they havent been off our display shelf. Turned on infrequently.
This is the only place where you can get these...and they're at dealer wholesale cost. Original boxes and all inserts. 
Really good mix speaker with advanced digital technology.
You can plug your input with an analog xlr cable or a digital AES for 24/96 D to A. or RJ45 digital input!