Save over £1000 with this exclusive stereo recording bundle, featuring a pair of sE T2 Titanium-diaphragm condenser mics, ISA Two pre-amp, Reflexion Filter Pro acoustic vocal screens, dual pop shields and cables.Focusrite ISA Two and sE Electronics T2 Titanium Stereo Recording Bundle Main Features Superb quality stereo recording Titanium diaphragms for unrivalled transient response Multi-pattern selection for variety of recording techniques Reflexion Filters, Pop Filters and Cables included
Package consists of: 1 x Focusrite ISA Two Dual Channel Mic Pre-Amp 2 x SE Electronics T2 Studio Condenser Microphones 2 x SE Electronics RF Reflexion Filter Pro 2 x SE Electronics Dual Pro Pop shields with metal/fabric shields and gooseneck 2 x Horizon 6 metre XLR to XLR Neutrik Lo Z Mic Lead Cables, Red (NBM5-20R)
SE Electronics T2 Studio Condenser MicrophoneThis mic is the ultimate combination of solid state performance and versatility. Based on the chassis and feature spec of the acclaimed 4400a, but with the highly specialised capsule of the original Titan, it delivers full and perfectly balanced mid and low frequencies, while its Titanium capsule produces un-hyped but ultra-detailed HF response.It is thus ideally suited for percussive recordings, including studio use for drums (and of course percussion), picked guitar, hammer action on piano, kick drum, slap bass etc.More, it is the ideal broadcast mic for spoken word. Since the intelligibility of any speech recording comes with good definition of HF (the percussive elements of speech such as ‘p' and ‘t' sounds), it is especially important for any mic used to deliver great HF response. However, simply hyping the HF with an EQ bump can cause the sound to be sibilant and harsh sounding. The T2 delivers perfectly balanced HF response due to its very fast HF transient response, giving exceptional intelligibility without the hype.Perfect for percussion, perfect for spoken word.Specifications Frequency Response: 20Hz-20KHz Sensitivity: 28mv/pa-31 ± 1dB Polar Pattern: Omni, Cardioid, supercardioid, Figure 8 Impedance: ≤ 50 Ohms Equivalent Noise Level: 14dB(A weighted) Max SPL for 0.5% THD@1000Hz for 0.5%: 140dB minimum Power Requirement: Phantom power 48V±4V Connector: 3-pin
Focusrite ISA Two Dual Channel Mic Pre-AmpThe Focusrite ISA Two features two channels of Focusrite's classic transformer-based premium microphone preamplification, their cornerstone design which has contributed to the signature sound of many hit records across the past four decades. Each channel has balanced insert points, variable high-pass filter, and of course, the now customary variable input impedance allowing you to get the very best results from any microphone.
The Focusrite ISA Two features up to 80 dB of low-noise gain as well as variable input impedance, allowing you to get the best from any type of microphone. In addition to the microphone inputs, transparent DI inputs with front panel access and rear panel TRS line inputs are provided, making ISA Two the ideal premium dual channel front-end to your DAW.Each channel has a variable cut-off high-pass filter, the design of which has remained unchanged since its introduction in the first ISA 110 module during the 1980's. With attenuation of 18 dB/Octave the filter has a variable cut-off frequency of 16 to 420 Hz - easily controlled with the large dial on the front panel. In addition to the filter, each channel has phantom power, phase-invert and a rear panel insert. Each of these features can be switched in and out via the front panel.Finally, a meter is available for each channel. Eight-segment LED arrays clearly display the level of your two signals. By using the calibration knob on the rear panel, you can line up your analogue levels with your converters or DAW. You will be safe in the knowledge that clipping has been avoided